Step 1: Run and store ultrasonic measurements
1. Press the F3 key to enter the measurement setup menu. Use the up and down arrows to adjust the acquisition time.
2. The acquisition time is set to 0s, then RMS, maximum RMS, peak and crest factor are refreshed every 250ms. This mode collects data on the fly.
3. When the acquisition time is set above 1s, the RMS, peak and crest factor will be calculated within the entire data acquisition time. The maximum RMS is the maximum value during the entire acquisition time. Each sub-RMS is calculated within 250ms with a maximum acquisition time of 10s.
4. Use the F1 key to save the settings as the first setting. The F2 key loads the relevant first configuration settings. Use the F3 key to return to the measurement interface with the modified settings.
5. Get the data and press the M key. Fixed RMS and maximum RMS values when the acquisition time is set to 0s.
6, click F3 or save button to save data appears
Use the up and down keys to select the desired memory location and press the Enter key. The instrument will automatically save the data in the corresponding sensor type memory.
Step 2: Run and store temperature measurements
1. Press the F1 key to select the temperature measurement T, the F2 key activates or deactivates the laser pointer, and presses the F3 key to enter the measurement setup menu.
2. Adjust the emission coefficient (0, 01-1) to switch between Celsius and Kelvin physical units.
3. Press the up and down keys to select the amount to be switched. Use the left and right keys to switch. The F1 key saves the setting as the first setting, the F2 key loads the related first configuration setting, and the F3 key uses the modified setting to return to the measurement interface. The storage method is the same as the ultrasonic wave. Measurement, F1 cancels measurement storage.
Step 3: Review the stored measurement data
1 Click the Enter button to go from the measurement screen to the main menu;
2 Click the left and right button to select;
3 Click the Enter key to enter the + sign to indicate that the path has been stored, use the up and down keys to select the path, and right click to expand the memory location;
4 Click the up and down keys to select the desired sensor and right click to display the saved measurement data. Enter key to open the data;
